My course consists of a branching simulation with a pre-test and post-test, each consisting of essay-type questions. Prior to publishing a check shows that there are no errors present. At the end of the publishing process some seven errors have been found in the post-test. Each states "The is a ChangeContent action on this page with an invald destination." This has left me somewhat confused because:
1.The post-test pages are essentially identical to the pre-test pages except that the wording is different (naturally!) and the pre-test pages haven't generated any error comments
2. I haven't used Change Content actions anywhere in the course
3. The only actions on the relevant pages are those associated with 'next' buttons i.e. goto next page.
4. Prior to completing the course the pre-and post-test sections were publshed as a self-contained unit in order to test the cgi process for capturing variables by email. This was successfull and no error messages generated. Nothing in the post-test has been changedsince, as far as I am aware.
I'm at a loss to know where to go next.
